Stop Leaks with Expanding Polyurethane Foam
Spetec PUR HighFoamer is a one-component, closed-cell, hydrophobic, water-reactive, solvent, and phthalate-free, low viscosity resin. It’s most commonly used for high-flow water leak shut-off and stabilization. It has a high rate of expansion combined with a lot of flexibility. For similar products, see the page on Leak Seal.
Available Sizes
Applications
- Water cut-off of large flow and high pressure water leaks.
- Water cut-off of water leaks in foundations such as diaphragm walls, piling sheets and secant piles.
- Stabilization and water cut-off of large cracks, voids and gravel layers.
- Pre and post injections in mines, tunnels, pipe jacking, drill & blast and TBM applications.
- Injections in combination with cement-based grout.
- Crack and gravel layer injections in concrete structures.
- Soil stabilization and anchors in porous geology.
- Water cut-off of sewer water leaks and sewer stabilization.
- Probe grouting for below grade pipes.
- Manhole injections.
Advantages
- One component.
- Different reaction times are possible by adjusting the percentage of GEN ACC Accelerator.
- The closed-cell structure of cured polyurethane ensures permanent sealing of cracks and joints.
- Cured polyurethane exhibits high strength and good chemical resistance (contact our Technical Service for chemical resistance).
- Cured polyurethane is harmless for the environment and resistant to biological attack.
- Certified To NSF/ANSI/CAN 61 (approved for contact with drinking water).
Accessories
- GEN ACC Accelerator
- AP Pump Flush
- AP Soak 130
Equipment
- Single component airless sprayer recommended.
